Dodge RamCharger Central banner

PCM Connector Assembly

1K views 3 replies 2 participants last post by  DODGEBOYS 
#1 ·
I took the white middle PCM connector apart due to thinking it was making a bad connection.  Trying to put it back together.  Does anyone know how to get this connector back together?  So far I am not having any luck.

What was happening a little over a week ago I had a No Start,  finally decided to replace the PCM as it seemed to not be working.  Order a replacement put it on started right up, drove it for two days then started having problems again but this time found that messing with the PCM connector mainly the White center one it would start but only to quit again.  That is why I took the connector apart.  Thank You for any help that you can provide.

Oh  This is a 2001 Dodge Durango 4.7
 
#2 ·
you actually took it apart = all the locks and anti-tamper proof stuff and pulled all the wire terminals out / they make special tools and dielectric grease to do something like that and it aint for the faint of heart because only the most experienced mechanics should attempt that / sad to say your in way over your head and need the help of a PRO mechanic because they dont even show howto take those apart in a FSM [ factory service manual ]
 
#3 ·
I see how it should work now that I have better light.  However sure not easy to keep the pins locked in and sliding the rest of the connector together.  I've tried two different ways,

I guess worst case would be to get a connector from a junk yard and spice it on. 

Well 37 years in Electronics and Audio wiring a multipin connector does not bother me too much normally.  Eyesight is not as good as it use to be and mainly a bit stressed out about this truck not running.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top