Author Topic: 4wheel drive doesnt work  (Read 508 times)

0 Members and 1 Guest are viewing this topic.

Offline GroundHawger

  • Jr. Member
  • ***
  • Posts: 766
  • Gender: Male
4wheel drive doesnt work
« on: October 21, 2002, 05:08:00 PM »
On my ramcharger, if u put it into fourwheel drive, it goes in, but the front doesnt do anything, the driveshaft will spin, but thats it, it acts as if the ring and pinion is stripped out. I was told to check the canister on the axle. How can i tell if that is bad or not? Thanks
84 R/C
8 inch lift
built 360
built 727/208
Rancho RS 5000'S
Custom Driveshafts
soon to have 39 inch boggers
AutoMeter Gauges
15x14inch rims
STILL NOT DRIVEABLE

Offline RAMMAN4

  • confederate cowboy
  • Mopar Nut
  • ******
  • Posts: 6467
  • Gender: Male
  • TAMUK Alumni
    • ain't yours
Re:4wheel drive doesnt work
« Reply #1 on: October 21, 2002, 05:15:41 PM »
The canister that they are talking about is the CAD unit on the front axle.  It's on the driver's side near the spring.  It'll be a small box unit that's bolted to the top of the axle tube.  Check to make sure there is vaccum pressure when you engage 4wd.  You should be able to engage it and then check for vaccum.  If there is no vaccum check the lines for breaks or if they came off.
1984 RC, 360 Magnum,600 cfm Holley,MSD ignition, 727, 4.10 gears, 4 inch suspension, 3 inch body, 36X12.50 Wrangler RT II. onboard air, crossover steering
1-46 INF, 3rd ACR, 433 SFS
www.ramman1.ramchargercentral.net 
www.fordkiller.ramchargercentral.net
www.heavyhauler1.ramchargercentral.net